What to look for in PepeTools Ultra Power Electric Combination Rolling Mill 130mm?
Center Dial 0-100 Regulates speed at which the rollers turn Forward Stop Reverse switch, On Off Switch. MAXIMUM ROLLER OPENING 0-7.5mm Rollers 130mm Length x 65mm Diameter - Mirror finished and induction hardened to 60-62 HRC. Rollers SQUARE mm 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, 4.0, 4.5 FLAT 66 wide x 65 diameter ELLIPSE, HALF-ROUND mm 2.5 x 1 and 3 x 1.25 and 4 x 1.5. Rolling Mill Body is one-piece precision cast construction for ULTRA strength and durability Industrial Grade - Heavy Duty Worm Gearbox* - Rated 12,000 Hours Continues Duty. Production Speed 0-12 RPM Production Output - 7.5 Ft min or 2.3 m min Roller Opening 0-7.5mm
Do you know what is the superiority of this PepeTools Ultra Power Electric Combination Rolling Mill 130mm?
epe Ultra Mills designed for cold rolling of nonferrous metals to produce uniform thickness and bright finish. You will be able to reduce thickness gauges of sheet metal and wire. Transfer textures to your metal, and many other related tasks. The T bar at the top of the Rolling Mill used to open or close the rollers. When completely closed the rollers, should measure true cylindrically. This means they should touch with no visible gaps. Should there ever be a gap, meaning the rollers are not true , simply remove the two small screws holding the T bar cover , pull the T bar handle off and turn the large gears to move the roller s down until there is no visible gap, making them true , then re-install the T bar and cover. To roll metal Open the rollers to accept the metal and close the rollers around the metal using the T bar until the rollers touch and hold the metal. Set the indicator dials on the large gears to 0 zero , Indicator Dials are on the top of each Rolling Mill. Turn on the Power Mill and Select Forward. Select Speed at which the Roller moves with the Center Dial 0-100 . Tests pass the metal through. Once the test pass been completed, you will want to turn the T bar clockwise one quarter of the space between the markings on top of the gears, any greater distance could damage the mill. Continue to pass the metal through the rollers until the desired thickness is achieved.
Customer reviewsWould highly recommend